Waterflex Fit's Pool Guide D'installation & D'utilisation page 38

Holes for the pump connectors
Step 5 : Installation of the angles
The bevelled panels must be inserted by the in-
terior of the structure with the bevelled sides in
each of the corners.
Locate the panel with the hole for the drainage
adapter; it must be on the same side as the holes
for the pump connectors on its right.
Step 7 : outer liner (continued)
Close the liner zip gently. If you feel any resist-
ance, adjust the liner in the structure.
38
6. INSTALLATIoN
Hole for the drainage
adapter
Step 6 : outer liner
Locate the round holes of the pump unit on the
liner to match them with the holes of the struc-
ture.
To facilitate positioning, open the liner zip.
Drag the liner over the structure.
The angles must be positioned correctly with re-
spect to the structure.
Step 8 : Flip
Flip the structure the right way up; the base of the
liner should rest on the ground.