How To Adjust The Temperature For Different Requirements; Ice Maker Activation; Information And Malfunction Messages On The Display - Fhiaba 1T Mode D'emploi

Refrigeration Compartment
Crisper-Fresco Compartment
The temperature shown can vary slightly in re-
spect to the set temperature following frequent
openings of the doors or insertion of room tem-
perature foods or large quantities of foods.
6 to 12 hours are necessary to reach the select-
ed temperature.
Do not activate the Ice Maker unless the appli-
ance is connected to the water mains.

How to adjust the temperature for different requirements

Each model has been carefully tested before leaving the factory and is
adjusted in such a way to ensure high performance and low consump-
tion. Usually, it is not necessary to modify the settings.
Nevertheless, according to special needs, it is possible to modify the set
temperatures as follows:
From +1°C to +7°C (from 33,8°F to 44,6°F), the recommended preset
temperature is +4°C (39,2°F).
To adjust the temperature use the Up/Down buttons
these buttons the newly set temperature will appear in the display. To
modify this temperature, use the buttons until reaching the desired tem-
perature.
From -2°C to +2°C (from 28.4°F to 35.6°F), the recommended preset tem-
perature is 0°C (32°F).
To adjust the temperature use the Up/Down buttons
these buttons the newly set temperature will appear in the display. To
modify this temperature, use the buttons until reaching the desired tem-
perature.
Freezer Compartment From -13°C to -23°C (from 8,6°F to -9,4°F), the recommended tempera-
(TriMode) ture is preset at -18° (0°F).
To adjust the temperature use the Up/Down buttons
these buttons the newly set temperature will appear in the display. To
modify this temperature, use the buttons until reaching the desired tem-
perature.
In case the compartment is used as refrigerator or Crisper-Fresco com-
partment (TriMode function) the recommended and preset temperatures
will correspond to those indicated for the respective compartments.
The Ice Maker button
tivation of the automatic icemaker. The button is lighted when the ice-
maker is functioning.

Information and malfunction messages on the display

An integrated control system provides information through light signals or
text messages visualized on the display.
a malfunction signal is visualized with blinking text. The sound signal that
accompanies some malfunction signals can be deactivated by pressing
the Alarm button
The list of malfunction signals is located at the back of this manual.
Appliance switching on and off

Ice Maker Activation

located on the main control panel permits ac-
on the main control panel.
4
4.2
. Upon touching
. Upon touching
. Upon touching
4.3
4.4
13