Appliance Switching On And Off; Switching On And Off; How To Adjust The Temperature For Different Requirements - Fhiaba 1T Mode D'emploi

4. APPLIANCE SWITCHING ON AND OFF

4.1 Switching on and off

First startup
When the appliance is connected to the electrical
power supply but has not yet been switched on,
the display shows the message
This is a safety message to warn that the ap-
pliance is connected to the mains, and all the pa-
nel buttons are off.
To switch on all the appliance compartments,
press the Unit button for three seconds.
When the appliance is first switched on is recco-
mended to wait at least 12 hours without opening
the doors and before placing any food inside the
unit.
During such period deactivated any error messa-
ge by pressing the Alarm button.
Switching off the Refrigerator
and Fresco compartments
Press Fridge or Crisper button for three seconds.
Switching off the TriMode compartment
Can only be switched off by switching off the
whole unit.
Press Unit for three seconds.
Restarting
Use the same buttons to restart.
The freezer compartment always stays on and
cannot be switched off except by completely
switching off the appliance by pressing the Unit
button for three seconds.
Switching off for long periods
During long absence periods it is recommended
to switch off the refrigerator by pressing the Unit
button for three seconds and disconnecting the
electrical plug or the breaker controlling the so-
cket.
Completely empty the refrigerator, clean and dry
it and leave the doors and drawers partially open
to prevent unpleasant odors.
If at the first startup the Standby message
does not appear, but another message appe-
ars, it means that the appliance has already
started the cooling process. If this is the case,
deactivate any possible sound signal by pres-
sing the Alarm button
wait until the set temperature is reached.
.
, close the door and
www.fhiaba.com · info@fhiaba.com · Info Line 800-344222
During the first startup, it will not be possible
to use the Menu to modify the factory settings
until the preset temperature has been rea-
ched.
Each time the appliance is switched on it goes
trough a self-diagnosis procedure lasting th-
ree minutes before completely starting up.
If only the refrigerator compartment or the
Crisper-Fresco compartment is switched off,
the specific fan will continue to operate to
prevent the formation of unpleasant odors
and mold.
Before switching off the appliance for a long
period of time, remove all of the items inside
and leave the doors and drawers open to pre-
vent the formation of unpleasant odors and
mold.
4.2 How to adjust the temperature for
different requirements
Each model has been carefully tested before lea-
ving the factory and is adjusted in such a way to
ensure high performance and low consumption.
Usually, it is not necessary to modify the settings.
Nevertheless, according to special needs, it is
possible to modify the set temperatures as fol-
lows:
Refrigeration Compartment
From +1°C to +7°C (from 34°F to 46°F), the re-
commended preset temperature is +4°C (39°F).
To adjust the temperature use the Up/Down but-
tons . Upon touching these buttons the newly set
temperature will appear in the display. To modify
this temperature, use the buttons until reaching
the desired temperature.
Vano Crisper - Fresco (sui modelli 1T)
From -2°C to +2°C (from 28°F to 36°F), the re-
commended preset temperature is 0°C (32°F).
To adjust the temperature use the Up/Down but-
tons . Upon touching these buttons the newly set
temperature will appear in the display. To modify
this temperature, use the buttons until reaching
the desired temperature.
Freezer Compartment (TriMode)
From -13°C to -23°C (from 9°F to -11°F), the re-
commended temperature is preset at -18° (0°F).
To adjust the temperature use the Up/Down but-
tons . Upon touching these buttons the newly set
temperature will appear in the display. To modify
this temperature, use the buttons until reaching
the desired temperature.
EN
11