Before Lighting; Lighting Instructions - Blumfeldt 10035366 Mode D'emploi

OPERATION
WARNING
Danger of personal injury
Before proceeding, make certain that you have assembled
the appliance according to instructions. Never use your
fireplace in a building, garage, shed, breezeway, or any
other enclosed area. Never obstruct the flow of ventilation
air around your gas grill housing.

Before lighting

Inspect the gas supply hose prior to turning the gas "ON". If there is evidence
of cuts, wear or abrasion, it
must be replaced prior to use. Check leakage before use. Do not use the grill
if the odor of gas is present.

Lighting instructions:

1. Ensure that unit valve dial is in the "off"position by pushing and turning
clockwise until the dial stops.
2. Securely attach regulator(large end of hose) to your cylinder.
3. Extend hose to full length and ensure that the propane tank is as far as
safely possible from the Fire Bowl.
4. Slowly turn cylinder valve to"HIGH"position,push the IGNITE to light the
fire pit.
5. After fire pit lights, release control knob. Push in and turn the control
knob to the "HIGH", then release control knob. If you want a lower
temperature, push in the control knob and turn counterclockwise to the
"LOW"-
If the burner does not light within 30 seconds, turn the valve off and wait
5 minutes for any gas to dissipate before repeating the procedure. To shut
down the burner, turn the burner control knob clockwise to the off position.
Then turn the gas off at the source.
EN
29