Lighting Procedure - Blumfeldt Goldflame Deluxe Mode D'emploi

EN
Note: In the event of gas leakage, the appliance must not be used or if already
alight, the gas supply must be shut off and the appliance investigated and
rectified before it is used again.
Minimum clearance from combustible surfaces
This heater is primarily used for the heating of outdoor patios, decks, spas,
pools and open working areas.
Combustible materials are considered to be wood, compressed particle
boards, plant fibres, plastic or other materials that are capable of being ignited
and burned.
Always make sure that adequate fresh air ventilation is provided. Follow the
spacing tolerances shown in the following figure right at all times.
This heater must be placed on level, firm ground.
Never operate in an explosive atmosphere. Keep away from areas where
gasoline or other flammable liquids or vapours are stored or used..

Lighting procedure

1. Turn the control knob OFF. Slowly open the gas cylinder valve.
2. Push in and turn control knob anti-clockwise to IGNITE.
3. Keep control knob depressed for up to 30 seconds until pilot is lit.
If pilot does not light, turn control knob to OFF and wait 2 minutes between
34