Maintenance; Disposal - Habegger HIT-06 Manuel D'utilisation Original

TGT, 26.06.2017
7

Maintenance

Perform the following checks and maintenance work:
Work
General visual inspection:
- casing
- anchor bolts and retaining disc
Screw inspection
Cleaning
Lubrication
Rope: Visual inspection
– Clamp
– Load hook with catch
Rope: Diameter check
The device, rope and accessories must be checked by an expert at least every 2 years (see sticker
on device). All of the parts will be checked for deformation, wear and tear and cracks. The inspec-
tion results must be entered into an inspection log or on page 4 of this booklet.
The operator must order the inspections.
Additional inspections must also be performed by an expert at shorter intervals in accordance
with the local regulations and under harsh operating conditions.
8

Disposal

Comply with national disposal regulations.
When disassembling the device, separate defective parts by material type as much as possible in order to recycle them:
Store or recycle metal and plastic parts separately.
Remember, protecting the environment and recycling materials benefits us all.
Replacement parts lists
The replacement parts lists for the four pulley devices can be found on the last pages of these instructions.
©Copyright by Habegger Maschinenfabrik AG
Betriebsanleitung
Technik
when as
starting needed
work
X
X
X
X
X
X
X
X
Remarks
After first use or modification
In the event the device is very dirty, clean with
a pressure washer
If necessary, disassemble the casing and re-
move dirt/foreign objects
Drizzle in engine oil
After using a pressure washer:
Soak the device in engine oil and let the oil
drip off.
The clamping jaws and rope must remain dry.
Check for deformation, damage or breaks
if the rope is worn, replace it
See Chapter 3 for values
Seite 46 von 52
Version 03 / 26.06.2017