Safety Gear - Habegger HIT-06 Manuel D'utilisation Original

TGT, 26.06.2017
5.1

Safety gear

BLOCSTOP BS, hand operated
Safety gear BS
Suitable for manual pulley device
Load-bearing capability when transporting persons *
Rope D on the safety gear
* 1 kN corresponds to approximately 102 kg
While lifting a load or tensioning a wire rope the rope passes through the BLOCSTOP. There is no need
to operate the BLOCSTOP.
For lowering the load or releasing the wire rope the BLOCSTOP is opened by lifting the operating lever
upwards.
Blocstop BSA, automatic slack wire rope device
Safety gear BSA
Suitable for manual pulley device
Load-bearing capability when transporting persons *
Rope D on the safety gear
* 1 kN corresponds to approximately 102 kg
The BLOCSTOP can only be used on a secondary safety wire rope in parallel with a main suspension wire
rope. The BLOCSTOP is rigidly mounted and operated by the tensioned suspension wire rope. This sys-
tem not only protects against suspension wire rope failure or hoist malfunction but also against exces-
sive slope of the cradle.
Blocstop BSO, overspeed
Safety gear BSO
Suitable for manual pulley device
Load-bearing capability when transporting persons *
Rope D on the safety gear
* 1 kN corresponds to approximately 102 kg
The BLOCSTOP protects against hoist failure and, if mounted on a separate safety wire rope, against
suspension wire rope failure.
This BLOCSTOP operates at a certain "speed limit" which is directly related to the speed of the wire rope
passing through the BLOCSTOP.
©Copyright by Habegger Maschinenfabrik AG
Betriebsanleitung
Technik
BS 15.301
HIT-06
6 kN
8.3 mm
BSA 15.301
HIT-06
6 kN
8.3 mm
BSO 500
HIT-06
5 kN
8 mm
BS 20.303 BS 20.301
HIT-10 HIT-16
8 kN 12 kN
9.5 mm 11.5 mm
BSA 20.303 BSA 20.301
HIT-10 HIT-16
8 kN 12 kN
9.5 mm 11.5 mm
BSO 1020 BSO 2050
HIT-10 HIT-16
8 kN 20 kN
9 mm 14 mm
Seite 44 von 52
BS 35.30
HIT-32
24 kN
16.3 mm
BSA 35.30
HIT-32
24 kN
16.3 mm
Version 03 / 26.06.2017