Table des Matières
Publicité
Setting Locomotive Parameters with the Control Unit
1. Requirement: Setup as in diagram 1. Only the locomotive to be changed can be on
the track.
2. Press the "Stop" and "Go" at the same time until "99" blinks in the display.
3. Press the "Stop" button.
4. Enter the address „80".
5. Hold the speed control knob in the reverse direction position constantly. Press the
"Go" button while you do this. The headlight on the locomotive will blink. If no,
repeat starting at Step 2.
6. Enter the register number for the parameter to be changed .
7. Activate the direction reversal.
8. Enter new value.
9. Activate the direction reversal.
10. End the procedure by pressing the "Stop"
button. Now press the "Go" button.
Betrieb • Operation • Fonctionnement • Exploitatie
Diagramm 1
80
1
2
01
01
2
1
Parameter
Address
Acceleration delay
Braking delay
Maximum speed
Reset to series values
Volume
16
99
1
1
80
1
1
10
1
2
1
Register
01
03
04
05
08
63
10
1
Value
01 - 80
01 - 63
01 - 63
01 - 63
08
01 - 63
Publicité
Table des Matières
