Front Glass Installation; Finishing - Continental Fireplaces CEFL32FH Instructions D'installation Et D'opération

Foyer électrique
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING
!
Power supply service must be completed prior to finishing to avoid reconstruction.
Heat vents and air openings cannot be covered in any circumstances.
3.1

front glass installation

WARNING
!
Glass may be hot. Do not touch glass until cooled.
If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
Before door is removed, turn the appliance off and wait until appliance is cool to touch. Doors are heavy and
fragile so handle with care.
Before installing the front glass, remove the screws securing the paper board on the inside of the
A.
appliance that protects the control panel. Discard the paper board.
Reinstall the screws,see Figure 1. (For recessed installed appliances only)
B.
Remove the 2 screws from the top of the appliance.
C.
Have two people, lift the glass up and away from the appliance, holding the glass vertical not flat while
D.
carrying. Place the glass face down onto a soft, non-abrasive surface, careful not to flex the glass.
Bend the top tabs flat, see Figure 2
E.
Install the crystal embers, refer to "crystal ember installation" section.
F.
Install the front glass by aligning with the pins on the appliance. Press the glass in and down to securely
G.
engage with the brackets. It must be fully engaged to ensure the touch display panel performs properly.
Secure the front glass using the screws provided to the top of the appliance, see Figure 3. (If fully
H.
recessed this is not necessary)
FIG. 1
FIG. 2
FOR MODELS CEFL50/60/72/100FH ONLY:
For NEFL50FH, NEFL60FH, NEFL72FH, NEFL100FH
Pin
Paper
Please take off the screws, move off the paper board, then fix the screws back.

3.0 finishing

finishing
47.1
Paper
W415-1730 / B / 07.28.17
EN
17

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Cefl42fhCefl50fhCefl60fhCefl72fhCefl100fh

Table des Matières