SOUNDMASTER high line TR 50USB Mode D'emploi page 12

Station Search
(i) Scanning by hand:
Turn "TUNE/LOCK"knob to scan the radio stations. The step-frequency is 0.1 MHz for FM and 9 KHz for AM.
(ii) Scanning automatically:
Press "UP" or "DOWN" key to start scanning automatically, you will find the frequency numbers (8) Figure III
changing on LCD display. It stops scanning and start to play while a radio station is searched.
Attention:
Press "UP" or "DOWN" key again while scanning, it will stop on the current station scanned.
(iii) Scan and memorize the radio stations
Press "M-SCAN" key to start scanning radio stations automatically from low to high frequency and memorize
all the scanned stations, then press "M+" or "M-" key to select the scanned stations you desired.
(iv) Select the memorized stations
If the radio stations have been memorized with using "MEM" key, press "M+, M-" to select the memorized
stations, you can select these stations from "001" to "100" if 100 stations have been memorized.
(2) Station Memories
When you are listening to the radio , press "MEM" key, the memories position of "001" (3) Figure III and the
symbol of "PRESET" lights up and keeps jumping, turn "TUNE/LOCK" to select which position the stations
will be memorized, then press "MEM" key again, the station you are listening to has been memorized in the
position you just selected. If you succeeded to save the station, the position numbers and the symbol of
"PRESET" will stop winking and shift to show the information of signal-strength automatically 3 seconds later.
Memories will disappear if not operating for 3 seconds. This radio has the capacity of 200 memories and 100
memories for AM, 100 memories for FM. Please refer to title (iv) above how to select the scanned radio
stations.
(3) Delete the memorized stations
If needed to delete some stations or adjust the memories position, press "M+, M-" to find the memories
position you want delete, and then press "MEM" key for seconds till the symbol of "DEL" (8) Figure III
indicated on LCD display to finish deleting.
(4) Select FM Mono and FM Stereo
Press "MO/ST" key, the symbol of stereo (1) Figure III lights up, which means you are listening to the FM
stereo radio program. Press again to return to FM Mono. A big noise may appear while you are listening to a
weak station, at this time you are suggest to close FM Stereo function for getting better S/N.
(5) AM Bandwidth and FM "Load and Deemphasis"
(i) AM Bandwidth
When listening to AM broadcasting, you can select the bandwidth reasonably to reduce the interference from
neighboring stations. You can set five bandwidth: 1KHz, 2KHz, 3KHz, 4KHz, 6KHz and select moderate
bandwidth for better listening. Press "IF STEP" key to set bandwidth while listening to AM broadcasting.
(ii) FM "Load and Deemphasis"
This function is set as per the different broadcasting system of different countries and regions to supply 50µS
and 75µS selections. Usually 50µS is used for some Europe countries and 75µS for China and some other
countries. Press "IF STEP" key to set while listening to FM broadcasting.
(6) LOCK
Press "TUNE/LOCK" knob, the lock symbol will light up, all keys and knobs loose effective at this time. Press
again till the lock symbol disappeared to finish.
(7) RESET
While replacing batteries wrongly or interfered by electromagnetism, the radio may be crashed. no display,
failing to power on, keys loosing effective but with display, display or switching off abnormally will come forth.
At this time, Insert a small hard stick less than 2.5MM in diameter (please do not use a metal stick) into the
hole of "RESET" and press till the clock time "12:00" (8) Figure III shown on LCD display to finish resetting.
You need re-adjust your radio after reset.