PRODUCT OPERATION
Using the Remote
NOTE: Before first use, pull away the small plastic tab located on the bottom of the remote to activate
the battery.
The remote has six functions:
The functions are non-effective when the heater is in standby mode, except for the power button.
1.
POWER - To power the unit ON/OFF
•
This will only work when the ON/OFF switch is in the on position.
When the heater is powered off, the fan will run for approximately 60 seconds before
•
powering off completely.
2.
OSCILLATION - Switches the oscillating function on or off.
3.
MODE - Changes the power settings:
Fan-only, Low power: 750W, High power: 1500W
•
4.
TIMER - Allows you to set the length of operation for up to 9 hours for automatic shut off.
•
Pressing the "TIMER" button increases the length of operation by 1 hour each time the
button is pressed.
•
Once the timer has been set, it will count down the hours in 1-hour intervals. When the
timer reaches zero, the heater will automatically shut off and enter standby mode.
Pressing the "TIMER" button once more when the display shows 9 hours will reset the
•
heater to run continuously.
5.
°C/°F - Switches the display temperature from Celsius to Fahrenheit.
6.
TEMP - Increases the temperature in 1°F increments. (59-95°F range)
•
When increasing the temperature using the "TEMP" button, press the button repeatedly
rather than holding your finger over it for a prolonged period. After 95°F, the
temperature will reset to 59°F.
6