arjo Enterprise ENT-ACC34 Mode D'emploi page 3

ENT-ACC34 replaces the standard head end panel on Arjo Enterprise® 5000, 8000 and 9000
series beds. It is intended for use in ITU departments where easy access to the patient's head
and upper body is required.
Refer to the bed instructions for use to confirm compatibility before using this accessory.
If a serious incident occurs in relation to this medical device, affecting the user, or the
patient then the user or patient should report the serious incident to the medical device
manufacturer or the distributor. In the European Union, the user should also report the
serious incident to the Competent Authority in the member state where they are located.
Installation & operation
1. Apply the brakes.
2. Remove the standard head end panel from the bed.
3. Install the ITU panel in the head end panel mounting holes (1), with the angled
bottom tube (2) inboard of the lifting pole sockets (3) as shown.
4. If the bed is equipped with end panel locking catches, rotate them a quarter turn
to lock the ITU panel in place.
5. When the ITU panel is installed, the handles (4) can be used to push the bed.
2
3
1
WARNING
4
EN