Safety Instructions; Installing The Battery Monitor - ProCharger 10037598 Mode D'emploi

supplier accepts no liability for damage caused by improper or
incorrect use.

4.2 | Safety instructions

WARNING!
Danger for children and persons with reduced
physical, sensory or mental abilities (e.g. partial-
ly disabled persons, elderly persons with reduced
physical and mental abilities) or lack of experien-
ce and knowledge (e.g. older children)!
• Store the ProCharger Battery Monitor away from
children.
• The kit includes small parts which could be
swallowed, and plastic packaging fi lm. Keep
these parts out of the reach of children to
avoid the danger of swallowing and choking or
suffocation.
NOTE!
Risk of damage!
Improper handling of the ProCharger Battery
Monitor can lead to device damage.
• Protect the ProCharger battery monitor from
mechanical impacts.
• Ensure the positive and negative terminals are
connected correctly.
28

5 | Installing the battery monitor

The integrated short circuit fuse ensures that the power sup-
ply is automatically interrupted if a certain current strength
is exceeded. Also, damage to the motorcycle and product is
prevented if the polarity is reversed thanks to the integrated reverse
polarity protection.
Attach the ProCharger Battery Monitor to the vehicle battery as
follows:
1. Disconnect the connections from your vehicle battery –
disconnect the ground connection fi rst of all. (To ensure you
don't lose all your vehicle settings, it may be suffi cient under
certain circumstances to only loosen the connections slightly
and not disconnect them entirely)
2. Connect the red cable terminal to the positive terminal and the
black cable terminal to the negative terminal and tighten the
connections again.
3. Fix the housing with the supplied hook-and-loop strap. Position
the hook-and-loop strap so that the Bluetooth signal is not
disturbed. Degrease/clean the surface before attaching the
hook-and-loop strap.
29