Technical Data - Roco 40410 Mode D'emploi

CV Name
59 Reset
(alternative to CV8)
64 Brace sectors
65 Offset register
66 Page register
67- Characteristic line
94
112 Fine tuning F1
113 Fine tuning F2
Tip for professionals
If you want to activate both of the couplings with the F1 function key, programme CV35 from 4 to 12.
Now program CV36 from 8 to 0 in order to ensure that the F2 function key no longer activates the 2nd
coupling.

Technical Data

Addresses:
Max. engine current/total load:
Function outlets:
Dimensions:
The decoder is preset at Address 03, an operation with 28 driving stages and can be driven and
programmed in DCC and Motorola** formats.
The function outlets of the decoder are especially designed for triggering the digital coupling from Roco.
* Märklin is a registered trademark of Gebr. Märklin & Cie. GmbH, Göppingen, Germany
** Motorola is a registered trademark of Motorola lnc. Tempe-Phoenix/Arizona (USA)
8040410920 VIII_2009.indd 15
Description
Reset to the works setting
If this CV is programmed with 1, the decoder is
reset to its works settings
Speed at the end of the braking sector
Valid if CV49 Bit2=1 & Bit7=1
Offset register for the CV progr. with the
Motorola** unit
Page register for the CV progr. with the
Motorola**unit
Characteristic line for driving stages 1-28
Increase this value if the travelling locomotive
should brake briefly when the coupling F1/F2 is
switched.
Lower this value of the travelling locomotive
accelerates briefly when the coupling F1/F2 is
switched.
Value Works
range value
0,1
00 – 63
00 – 255
00 – 255
00 – 255
different
ascending
values
00 – 255
1– 9999 (Long DCC address)
1 A
1A each
22 x 12,5 x 5,5 mm
20.08.2009 10:42:59
0
30
0
0
13
15