IMG STAGELINE M-34CDP Mode D'emploi page 11

6 Operation
6.1 Remote control
1) To insert the batteries (2 × 1,5 V, size AAA),
remove the battery compartment cover on the
rear side of the remote control. Insert the batter-
ies as indicated in the battery compartment.
Close the compartment with the cover.
If the remote control is not in use for a longer
period of time, remove the batteries to prevent
any damage due to battery leakage.
2) When you press a button on the remote control,
always direct the remote control towards the
sensor (10). There must be no obstacles be -
tween the remote control and the sensor.
3) If the range of the remote control decreases, the
batteries are exhausted and must be replaced.
Used batteries must not be placed in
the household waste; always take them
to a special waste disposal, e. g. collec-
tion container at your retailer.
6.2 Replaying music titles
After applying the 12 V operating voltage, the MP3/
CD player is switched on. The display (1) will show
"Welcome".
First the player will read the CD. If no CD has
been inserted, the player will read the USB flash
drive. If no USB flash drive has been connected, the
player will read the SD / MMC memory card. If no
memory card has been inserted, the display will
show "NO DISC".
1) Insert a CD with the lettering facing up into the
slot (2) until it is pulled in automatically
and / or
connect a USB flash drive to the USB port (8) or
connect a hard disk (with individual power sup-
ply, if required) to the USB port
and / or
insert an SD/MMC memory card into the slot
SD/ MMC CARD (9), the notched corner of the
card to the right.
2) Select the sound carrier (CD, USB flash drive,
memory card) with the button FUNC (11), if nec-
essary.
3) After reading in the sound carrier, the first title
will start automatically. However, if the auto-
matic start function has been deactivated (chap-
ter 4), press the button
start the first title. To select other titles see chap-
ter 6.3.
4) While replaying, the upper line of the display will
show the replay symbol on the right. The lower
[PLAY/ PAUSE]* (3) to
line will show the number (TR ...) of the current
title and the time already played of the title
(min. : sec.). At the far right, MP3 is shown for
titles in MP3 format or CDA for standard audio
CDs.
To switch between the indication of the time
already played of a title and the remaining time
of a title, press the button REMAIN (15).
5) For MP3 files, the following additional informa-
tion will scroll in the upper line:
File – ...
Title – ...
Artist – ...
Album – ...
Note: If an information is not available, the display will
show "Unknown" instead of a name.
To activate / deactivate this information scrolling
through the line, press the button ID3 (21).
6) When you press the button DISPLAY (20) on
the remote control, various information for MP3
files will be displayed in the lower line of the dis-
play:
basic setting
The bottom line will show the title number
and the time already played of the title or the
remaining time of the title.
first actuation of button
The folder name will be displayed.
second actuation of button
The number of folders and the number of
titles will be displayed.
third actuation of button
return to basic setting
7) Press the button
be tween replay and pause. In the pause mode,
the pause symbol will be inserted and the time
indication will flash.
8) When a title has been replayed and you wish to
set the player automatically to pause instead of
replaying the next title immediately afterwards,
press the button PLAY 1 (22) to set the player to
single tile replay: The display will briefly show
PLAY1 ON in the upper line and then perma-
nently the symbol
press the button
vate the single title replay, press the button
PLAY 1 once again.
9) To change the replay speed, turn the knob
PITCH (7) clockwise or counter-clockwise (indi-
cation on the display: SPEED -10 ... +10). To
return to normal speed, press the knob (indica-
tion: SPEED 0).
[PLAY/ PAUSE] to switch
. To start the next title,
[PLAY/ PAUSE]. To deacti-
GB
11