Warn 83405 Instructions De Montage page 8

INSTALLATION CONT.
12. Install the M10x1.25x45mm capscrews into
lower bumper mount, as shown in Figure
12. Verify they pass through the slots in the
winch mounting plate on inside of vehicle
frame tubes. Torque both upper and lower
bumper mount hardware to specifications
found on page 2. Reinstall lower factory
bumper hardware on front of skidplate.
13. Install the M10x1.5x20mm capscrews and
flat washers into vehicle frame through lower
slots of winch mounting plate, as shown in
Figure 13. Do not tighten at this time.
14. Install the M10x1.25 flange head nuts on
inside of winch mounting plate, as shown in
Figure 14.
Note: For easier installation use a u-joint
and extension placed in-between fairlead
mount brackets from front of bumper for
access to install nuts.
Torque these nuts and capscrews in step 13
to specifications found on page 2.
PAGE 8
Figure 12
M10x1.5x20mm cap-
screws
Figure 13
Figure 14
83406A0