Warn 83405 Instructions De Montage page 6

INSTALLATION CONT.
7. Remove capscrews from frame of vehicle
located near front differential, using a 14mm
socket, as shown in Figure 7. These cap-
screws will not be required when installing
winch mounting plate.
8. Assemble fairlead brackets and winch to
mounting plate in proper orientation, as
shown in Figures 8 and 8a. Bracket orienta-
tion dependent on which winch will be in-
stalled. Use M8x1.25x25mm capscrews and
lock washers to secure but do not tighten at
this time. Temporarily install fairlead using
M10x1.25x25mm capscrews to align fairlead
brackets and then torque 8mm hardware to
17lb. ft. (12.5 N-m). Remove fairlead from
assembly and cut plastic cable ties and elastic
band off winch.
Fairlead bracket orientation for RT/XT 40 installation
Fairlead bracket orientation for RT/XT 25/30 installation
PAGE 6
Remove capscrews
Figure 7
Figure 8
Figure 8a
83406A0