Senix GTS4QL-M2 Manuel D'instructions page 7

Installing the Attachment
1. If present, remove the gray spacer from the coupler
opening.
2. Set the unit on a flat, level surface.
3. Turn the knob counterclockwise to loosen the coupler
(Fig. 3).
4. Align the release button with the guide recess
(Fig. 4).
5. Push the attachment straight into the coupler until the
release button snaps firmly into the primary hole
(Fig. 5).
6. Turn the knob clockwise to tighten the coupler.
CAUTION:
Before operating the unit, make sure the release button
is fully snapped into the primary hole and the knob is
securely tightened.
CAUTION:
Unless specified otherwise, the release button should
be snapped into the primary hole only. Using the wrong
hole could lead to personal injury or damage to the unit.
Removing the Attachment
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise to loosen the coupler
(Fig. 3).
3. Press and hold the release button (Fig. 4).
4. Pull the attachment straight out of the coupler
(Fig. 5).
INSTALL THE HARNESS
The harness with quick release function can be hooked
behind the rear hand if needed (Fig. 5a).
NOTE: Harness use is optional.
WWW.SENIXTOOLS.COM
Tighten
Fig. 3
Guide Recess
Release Button
Fig. 4
Coupler
Fig. 5
Fig. 5a
Loosen
Knob
Primary Hole
Attachment
7