Cleaning The Air Filter - Senix GTS4QL-M2 Manuel D'instructions

CHANGING THE OIL
WARNING:
Old engine oil is considered special waste and has
to be disposed according to your local environment
protection regulation. Do not pour the oil into a garbage
can, sewer, soil etc.
Change the oil while the engine is still warm. The oil will
flow freely and carry away more impurities.
1. Clean the area around the oil fill plug (Fig. 20) to
prevent debris from entering the oil fill hole.
2. Unscrew the oil fill plug.
3. Tip the unit vertically to pour the oil out of the oil fill
hole and into a container (Fig. 22). Allow ample time
for complete drainage.
NOTE: Dispose of the old oil according to federal, state
and local regulations.
4. Wipe up any oil that may have spilled.
5. Pour 2.03 fl.oz. (60 ml) of SAE 30 oil into the oil fill
hole.
WWW.SENIXTOOLS.COM
Fig. 19
Oil Visible on
First Thread
Fig. 20
O-ring
Fig. 21
WARNING:
DO NOT overfill the oil level. Overfilling will result in
too much oil in the engine crankcase, and may cause
smoke or fumes that can injure the user.
6. Wipe up any oil that may have spilled.
7. Make sure the O-ring is in place on the oil fill plug
(Fig. 21).
8. Reinstall the oil fill plug.
Air Filter
MAINTAINING THE AIR FILTER
Failure to maintain the air filter can result in poor
performance or can cause permanent damage to
the engine. Engine failure due to improper air filter
maintenance is not covered by the product warranty.

Cleaning the Air Filter

1. Unscrew the cover screw completely. Remove the air
filter cover from the air filter housing (Fig. 23).
2. Remove the air filter from the air filter housing.
3. Wash the air filter in detergent and water. Rinse the
air filter thoroughly and allow it to dry.
4. Reinstall the air filter in the air filter housing (Fig. 23).
NOTE: Operating the unit without the air filter and air
filter cover will VOID the warranty.
5. Insert the tab on the air filter cover into the hole in the
air filter housing. Push the air filter cover back onto
the air filter housing. Insert the cover screw into the
air filter cover. Tighten the cover screw to secure the
air filter cover (Fig. 23).
NOTE: Do not overtighten as this may strip the screw.
Fig. 22
Air Filter
Air Filter
Cover
Housing
Cover Screw
Fig. 23
15