Assembly; Adjusting The Handle; Included Parts - Senix GTS4QL-M2 Manuel D'instructions

This product requires assembly. Carefully remove the
product and any accessories from the box. Make sure
that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product. If any parts are damaged or missing, please
call 1-800-261-3981 for assistance.
WARNING:
Do not use this product if any parts on the packing
list are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.

INCLUDED PARTS

Quantity Item
1 Fast Start Guide
1 Operator's Manual
1 Bump head (installed)
1 Harness
1 Fixed line head
1 Black .130 in. line
1 Cutting head shield and mounting screw
1 Torx wrench
1 Spark plug wrench
1 60 ml bottle of oil
1 Warranty statement
1 EPA warrantly letter
WARNING:
To prevent an accidental start that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
WARNING:
Never install, remove, or adjust any attachments while
power head is running. Failure to stop the engine can
cause serious personal injury.
INSTALLING THE CUTTING HEAD
SHIELD
1. Remove the screw from the cutting head shield.
2. Insert the tab on the mount bracket into the slot in the
cutting head shield (Fig. 1).
3. Rotate the cutting head shield until the hole on the
mount bracket aligns with the screw hole on the
cutting head shield.
4. Insert the screw and tighten until the cutting head
shield is firmly in place.
6

ASSEMBLY

Screw
Mount
Bracket
Cutting Head
Shield

ADJUSTING THE HANDLE

The handle can be adjusted for location on the shaft
and for angle of grip. To adjust handle:
1. Flip the lever down and turn the nut counterclockwise
to loosen the handle (Fig. 2).
2. Hold the unit in the operating position. Move the
handle up or down the shaft housing to a comfortable
location. Make sure the handle is positioned beyond
the end of the safety label.
3. Tilt the handle to the preferred grip angle.
4. Tighten the knob clockwise and flip the lever up to
secure the handle.
INSTALLING AND REMOVING THE
ATTACHMENT
In addition to the supplied line trimmer lower shaft, the
coupler on the upper shaft enables the use of various
other lower shaft attachments, available for separate
purchase.
WARNING:
Before using any attachment, read and understand the
manual that came with the attachment. Follow all safety
information contained within.
WARNING:
To avoid serious personal injury and damage to the
unit, shut the unit off before removing or installing an
attachment.
Slot
Tab
Fig. 1
Fig. 2
WWW.SENIXTOOLS.COM