Technical Drawings - Leuze electronic CML 720i Mode D'emploi

EN
Pin assignment
See "Electrical connection"
Configuration
You can configure the light curtain directly using the control buttons on the re-
ceiver. The display shows you the individual menu items, which are displayed/hid-
den depending on the configuration.
More conveniently, you can configure the light curtains of the CML 700i series us-
ing the IO-Link interface. We recommend our IO-Link master from the MD series
in this regard.
Configuration is performed using the Sensor Studio configuration software.
Download software
Ä Call up the Leuze home page: www.leuze.com
Ä
Enter the type designation or part number of the device as the search term.
Ä
The configuration software can be found on the product page for the device
under the Downloads tab.
In order to have the IODD profiles available, you should also download the IODD
files, as well as the IO-Link Device Collection .
More information can be found in the operating instructions.
Technical data
See chapter "Technical data" of the operating instructions

Technical drawings

2
CML 700i with axial or with rear connector outlet
All dimensions in mm
A Beam spacing
B Measurement field length
C IO-Link/analog devices: Connection to the primary control
PROFIBUS/CANopen/RS485 devices: Power In/Out + connection to trans-
mitter (Y-cable)
D IO-Link/analog devices: Connection to the primary control
PROFIBUS/CANopen/RS485 devices: fieldbus connection (Y-cable)
E Connection to receiver
F M6 thread
G Fastening groove
L Profile length
R Receiver
24