Winterizing And Long-Term Storage; Maintenance Instructions; Cleaning Tips - Kärcher G 2600 VH Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1: Disconnect all water connections.
2: Turn on the machine for a few seconds, un-
til the water which had remained in the pump
exits, turn off immediately.
3: Do not allow high pressure hose to become
kinked.
4: Store the machine and accessories in a
room which does not reach freezing tempera-
tures. DO NOT store near furnace or other
sources of heat as it may dry out the pump
seals.
Kärcher pump
Initial Use
All Kärcher pumps ship with oil already inside di-
rect from the factory. There is no need to add oil.
Pump Inspection
You should routinely make a visual inspection of
the pressure washer's pump. If you notice oil leak-
ing around the pump seals, you should take the
pressure washer to a Kärcher-Authorized Service
Center for repair. (You can locate a service center
Deck Cleaning
(with or without detergent). Pre-rinse deck and
surrounding area with fresh water. If using Kärch-
er Deck Wash, apply to surface at low pressure.
For best results, limit your work area to smaller
sections of approximately 25 square feet. Allow
Deck Wash to remain on surface 1-3 minutes. Do
not allow detergent to dry on surface. Rinse at
high pressure in a long sweeping motion keeping
the spray nozzle approximately 3-6 inches from
the cleaning surface. Always clean from top to
bottom and from left to right. When moving on to
a new section of the cleaning surface, be sure to
overlap the previous section to eliminate stop
marks and ensure a more even cleaning result.
CAUTION
Do not use Dirtblaster spray nozzle on wood
surface as it may cause damage.
12
English

WINTERIZING AND LONG-TERM STORAGE

MAINTENANCE INSTRUCTIONS

CLEANING TIPS

CAUTION
Failure to follow the above directions will result in
damage to the pump assembly and accessories
and will void the warranty.
Kärcher also recommends the regular practice of
using a pump protector like "Kärcher Pump
Guard" to prevent cold weather damage during
storage in the winter months.
in your area online at www.karcher-usa.com/ser-
vice.)
Pump Maintenance
The pump on your Kärcher pressure washer does
not require maintenance. Any attempts to service
or alter the pump may damage your pressure
washer and void your product warranty.
Engine
Carry out maintenance tasks for the engine ac-
cording to the specifications provided in the oper-
ating instructions provided by engine
manufacturer.
House Siding
(with or without detergent). Pre-rinse cleaning
surface with fresh water. If using Kärcher Pres-
sure Wash, apply to surface at low pressure (for
best results, limit your work area to sections of ap-
proximately 6 feet and always apply detergent
from bottom to top). Allow Pressure Wash to re-
main on surface 1-3 minutes. Do not allow deter-
gent to dry on surface, if surface appears to be
drying, simply wet down surface with fresh water.
If needed, use special wash brush attachment
(not included) to remove stubborn dirt. Rinse at
high pressure from top to bottom in an even
sweeping motion keeping the spray nozzle ap-
proximately 6 inches from the cleaning surface.
CAUTION
Do not use Dirtblaster spray nozzle on siding
as it may cause damage.

Publicité

Table des Matières
loading

Table des Matières