Burkert 2821 Notice D'utilisation page 5

Mechanical Data
Dimensions
Housing material
Seal material
Installation position
Pneumatic Data
Modes of operation
A
A
P
Pressure range
Line connections
12 GB
Electrical Data - Controller Type 1094
Operating voltage
Voltage tolerance
Residual ripple
Power consumption
Input signals
Input impedance
Output signal
Ramp time
Monitor signal
Electrical Data - Controller Type 8605
Operating voltage
Voltage tolerance
Residual ripple
Power consumption
Input signals
Input impedance
14
GB
type-dependent, see data sheet
brass, stainless steel
FKM, others on request
any, preferably with the actuator
upwards
Direct acting 3/2-way continu-
ous valve, closed by spring force
when currentless
see rating plate
see rating plate
24 V DC
±10%
±10%
0.5 W (not including valve)
0 to 20 mA, 4 to 20 mA,
0 to 10 V
210 Ω (for current input)
17 kΩ (for voltage input)
PWM (Pulse Width Modulation)
for valve actuation
0 to 10 s, adjustable
1 mV = 1 mA effective
coil current (for setting the
working range)
12 to 24 V DC
±10%
<5%
1 W (not including valve)
0 to 20 mA, 4 to 20 mA,
0 to 10 V, 0 to 5 V
<200 Ω (for current input)
>20 kΩ (for voltage input)
Rating Plate
Example:
Mode of operation
Nominal diameter
Type
Line connection
2832 A 2,0 FKM MS
G1/4 PNVAK - 8bar
24V DC
0 0 1 0 8 4
Voltage (±10 %)
Order No.
Electrical Data - Valve
Operating voltage see rating plate
Power consumption see rating plate
Standard operating continuous operation, duty cycle
mode 100% acc. to DIN EN 60034-1
Electrical connection stranded wires, connector lugs
(depending on type and acc. to DIN EN 175301-803
design) Form A, Form B
ASSEMBLY
Safety Instructions
WARNING!
Danger of injury during assembly of the valve.
• Such work may only be performed by authorized service
personnel and using suitable tools!
• After an interruption of the electricity or compressed air
supply, ensure that the process is restarted in a defi ned
or controlled manner!
Fluid Installations
DANGER!
Danger from high pressure!
Working on the unit involves acute risk of injury.
• Cut off pressure before detaching lines and valves.
Before assembly
Any installation position, preferably with the actuator up-
wards.
→
Before assembly, remove contamination from pipes and
fl ange connections.
Seal material
Housing material
8W
Pressure range
W11LA
Power
GB
GB
13
15