Power Supply - Quick HT4 Mode D'installation Et D'emploi

RRC Thrusters handheld transmitter
model HT4
WARNING: the transmitter needs to be programmed in the receiver's memory. To do this, follow the procedure
shown in the receiver's user manual.

Power supply

The handheld transmitter is powered using 3 AAA alkaline or rechargeable batteries.
To replace them, see the BATTERY REPLACEMENT paragraph.
Enabling
The handheld transmitter is enabled by keeping the ON/OFF button pressed. When pressed, it starts to flash regularly
and then starts flashing more quickly. After it is released, it remains on for 3 seconds and then, by means of a short
flashing, it shows that enabling has taken place.
If the ON/OFF button is released before it flashes quickly, the transmitter is not enabled and is off again.
Operational status
While pressing any key the blue transmission LED flashes quickly and signals that transmission has taken place.
Each key pressed corresponds to the activation of a relay (or 2 relays) on the receiver, which will stay active as long as
the key isn't released.
RRC HT4/8 - REV002A
Transmission LED
model HT8
Backlit ON/OFF button
OPERATION
EN
11