Tripp-Lite U457-1M2-SATAG2 Manuel De L'utilisateur page 5

Installation
4. Slide the M.2 connector on the SSD drive
5. Hold down the drive toward the drive
6. Replace the 2 drive tray screws on the front
7. Connect the included USB 3.1 Gen2
8. If your drive has not been formatted yet,
9. Your enclosure is now ready to use. The
16-12-187-93369E.indb 5
into the M.2 receptacle on the drive tray.
Note: The connector on the M.2 SSD is keyed so
the drive will only fit one way.
mounting hole. Using the included
screwdriver, drive the screw through the
mounting holes on your SSD drive and into
the drive mounting hole. Your M.2 drive is
now installed.
of the enclosure located on both sides of the
USB port.
Cable between the USB port on the
U457-1M2-SATAG2 and the USB port
on your computer.
you will first need to format it using your
computer's Disk Management Utility in order
to copy and access files.
blue LED light will blink to indicate reading,
writing and transferring of data.
5
1/23/2017 9:49:23 AM