DRILL DOCTOR XP Mode D'emploi page 58

2.
+
3.
56
Insert Chuck into
Alignment Port and adjust
bit position
To adjust the Chisel and Relief Angles,
simply align the bit as usual with the
following adjustment:
To
Chuck in the Alignment Port so that
the Alignment Guide is closer to the
(+) position. This will make a more ag-
gressive drill point.
To decrease Chisel and Relief—posi-
tion the Chuck in the Alignment Port
so that the Alignment Guide is closer
to the (-) position. This will make a
more precise hole. Take care not to ad-
just Relief too far as this will actually
cause the drill to lose all Relief and
therefore not drill a hole.
–
118˚
Tighten Chuck, and
sharpen as usual
Refer to pages 46-47 for these Steps.
Experiment with a few different set-
tings to find the one that best suits
your drill bits and application. You
may find it helpful to mark this setting
for future use.
increase Relief—position
Each notch in the Alignment
Port is approximately a 10°
change in Chisel Angle.
www.drilldoctor.de
the