Split Points - DRILL DOCTOR XP Mode D'emploi

Masquer les pouces Voir aussi pour XP:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Split Points

Split point drill bits prevent walk-around on the material before
they begin to cut. This feature is described as self-centering. The
need to center punch is effectively eliminated. A standard drill
bit chisel point has to wear an area in the middle of the hole to
be drilled before the cutting edges will remove material. Due to
its additional cutting lips along the chisel edge, a split point will
begin cutting immediately. Up to 70% less thrust (when compared
to a non-split or conventional point) is required to drill a hole with
a split point.
Optional Step: Splitting the Point
1.
2.
Splitting Port
Split Point Guide Rails
Sharpening Guide
50
Leave bit in chuck after
sharpening
Always align and sharpen a bit before
splitting it. To split the point, do not
remove the bit from the Chuck after
sharpening.
Align Guides
Align one of the Sharpening Guides on
the Chuck (short white marks) with
the Splitting Guide on the Splitting
Port. Port, making sure the Align-
ment Guides insert into the Split Point
Guide Rails in the Splitting
Splitting Guide
www.drilldoctor.de
Port.

Publicité

Table des Matières
loading

Table des Matières