Specific Safety Rules
WARNING! ALWAYS use proper safety glasses. Everyday
eyeglasses are NOT safety glasses. Also use face of dust mask if
operation is dusty. ALWAYS wear certified safety equipment:
• ANSI Z87.1 eye protections (CAN/CSA Z94.3)
• ANSI 512.6 (53.19) hearing protection
• NIO5H/OSHA respiratory protection
WARNING! Use of this tool can generate and/or disperse
dust, which may cause serious permanent respiratory or other
injury. Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body.
WARNING! This product contains a chemical known to the
State of California to cause cancer. Some dust created by power
sanding and grinding as well as contents from the machine may
contain chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
WARNING! Avoid prolonged contact with dust from power
sanding, sawing, grinding, drilling, and other construction
activities. Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or lie
on the skin may promote absorption of harmful chemicals.
Motor
Be sure your power supply agrees with the nameplate marking.
230 Volts AC only means your tool will operate on standard 50
HZ household power. Do not operate AC tools on DC. A rating of
230 volts AC/DC means that your tool will operate on standard 50
HZ AC or DC power. This information is printed on the nameplate.
Lower voltage will cause loss of power and can result in over-
heating.
Extension Cords
Make sure your extension cord is in good condition. When using
an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a
drop in line voltage resulting in loss of power and overheating.
The Drill Doctor® has a 1.75 ampere rating (.4 ampere in U.U.;
.74 ampere in Japan). The following table shows the correct size to
use depending on cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. The smaller the gauge number,
the heavier the cord.
40
www.drilldoctor.de