JB Systems FL30-RGB-ET-5050-3M Mode D'emploi page 4

ENGLISH
 Check that the available voltage is not higher than the one stated on the power adapter.
 In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. If the AC-
adaptor is damaged, a same model adaptor shall be used only.
 Don't connect the unit to any dimmer pack.
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
1. RGB CONTROL BOX: this box receives data from the IR-remote and controls the connected LED-strips.
2. POWER ADAPTER: just plug the 24Vdc output in the RGB-CONTROL BOX.
3. LED STRIPS: 6 lengths, each measuring 50cm are included. Using MIDDLE CONNECTORS (4) you
can easily plug the strips together, up to the desired maximum length.
4. MIDDLE CONNECTORS: needed to plug the strips and cables together.
5. LED CONNECTOR: should be connected to the first LED-strip in the row. Attention for the marking: see
next chapter.
IR REMOTE CONTROL:
6. ON/OFF buttons: used to switch the output on/off.
7. UP/DOWN buttons: has 2 functions.
 COLOR PRESET (8) selected: you can change the
dimmer level of the LED strips.
 COLOR FADE (9) selected: you can change the fade
speed from slow to fast.
8. COLOR PRESETS: You can choose one of the 3 basic colors
(red, green, blue) and 13 extra color presets, including white.
9. FADE MODE buttons: choose one of the available fade
modes to change colors. In this mode you can use the
UP/DOWN buttons (6) to change the fade speed. During color
fades the output is always at maximum.
10. BATTERY compartment: a 3volt CR2025-battery is already
installed. You just have to remove the small plastic protection
gently to make sure that the IR-remote can work.
INSTALLATION
Refer to the connection drawing in the previous chapter to put the different parts together.
A. First check how long the LED-strip should be: you can extend the LED-strip up to 3m using the supplied
50cm lengths. If the last strip is too long, you can eventually cut it on one of the cutting lines, using
scissors. Attention: only cutting on the markings (every 16,6cm, see below) is permitted!
JB SYSTEMS
®
2/19
OPERATION MANUAL
FL30-RGB-SET-5050-3M