JB Systems FL30-RGB-ET-5050-3M Mode D'emploi page 5

ENGLISH
B. Plug the different strips together using the MIDDLE CONNECTORS(4): see the connection drawing.
C. Thanks to the special self-adhesive 3M
First make sure to clean the surface and remove any greasy substance! Remove the protection paper
from the tape and press the strips gently in place.
D. Mount the RGB CONTROL BOX(1) somewhere out of sight but make sure that the INFRARED-capturer
can see the IR-remote at all times, otherwise the remote will NOT work!
E. Connect the LED strip to the output connector of the RGB CONTROL
BOX(1). Attention:
should correspond to the "+" marking on the LED strip.
F. Connect the POWER ADAPTER(2) to the input of the RGB CONTROL
BOX.
G. Connect the POWER ADAPTER TO THE MAINS outlet.
Important notice: The LED strips are IP65 waterproof but the connection system is not! If you want to use
the LED strips outside, add extra protection to the connections: put a thermal gain over the connectors
and/or use translucent silicon (used for bathrooms) on the connectors to protect them from water.
Hint: You can install the LED-strips also behind opal plastic panels to create color changing walls and
ceilings or in a bar you can install the strips under a translucent shelf to light up bottles and drinking glasses
from the bottom.
AVAILABLE OPTIONS:
You want to be even more creative with LED STRIPS? Check out these:
 T-CONN: A T-shaped connector so you can easily make a center tap on the LED strip line.
 L-CONN: An L-shaped connector to change the direction of the LED strip by 90°.
 DIFFERENT ALU PROFILES: used to make your installation simply perfect, with a professional look.
 DIFFERENT OTHER LED STRIPS: different strips and different lengths available.
 DIFFERENT LED CONTROLLERS: different LED controllers available from our LED MANAGER-line,
many with full DMX control!
CHECK OUT WWW.JBSYSTEMS.BE for more information on these products.
OPERATING INSTRUCTIONS
The LED strips are controlled by the IR-remote: check numbers 6 to 10 for the different functions.
SPECIFICATIONS
Power adapter:
Power consumption:
Light output (white):
Length:
Dimensions (W x H):
LED type:
Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited.
You can download the latest version of this user manual on our website: www.jbsystems.be
JB SYSTEMS
®
®
-tape you can attach the LED-strips easily on different surfaces.
see drawing, the small triangle on the connector
100-240Vac ~ 24Vdc/1A
6W /m
500lux@0,1m
3m (6 strips, each 50cm)
10 x 3mm
SMD-5050, RGB
Copyright © 2013 by BEGLEC NV
't Hofveld 2C ~ B1702 Groot-Bijgaarden ~ Belgium
All information is subject to change without prior notice
3/19
OPERATION MANUAL
FL30-RGB-SET-5050-3M