Christie LX120 Guide De Référence Rapide page 4

INPUT/OUTPUT TERMINALS AND JACKS
INPUT 2 INPUT 1
5 BNC INPUT JACKS DVI INPUT TERMINAL
Connect component video output Connect computer output
(Cr, Y, Cb or Pr, Y, Pb) from video (Digital/Analog DVI-I type)
equipment to R/Pr, G/Y and B/Pb to this terminal.
jacks or connect computer HD (HDCP Compatible)
output [5 BNC Type (Red, Green, signal
Blue, Horiz. Sync and Vert. connected.
Sync.)] from computer to R/Pr,
G/Y, B/Pb, H/HV and V jacks.
INPUT 3 INPUT 4
AV INPUT (VIDEO/Y, C) JACKS HDB 15-PIN INPUT TERMINAL
Connect composite video output Connect computer output
from video equipment to VIDEO/Y (Analog HDB 15-pin type)
jack or connect Separate Y/C video to this terminal.
outputs to VIDEO/Y and C jacks.
INPUT 1, 2, 3, 4
AUDIO INPUT JACKS
Connect audio output
from computer or video
equipment to these
jacks.
can also be
INPUT 1, 2, 4
CONTROL PORT
CONNECTORS
The port
functioning in this
model.
INPUT 3
S-VIDEO INPUT JACK
Connect S-VIDEO
output from video
equipment to this jack.
SERIAL PORT
IN TERMINAL
If you control a projector by
computer, you must connect a
cable (not provided) from your
computer to this terminal.
SERIAL PORT
OUT TERMINAL
This terminal outputs
signal from SERIAL PORT
IN. More than two
projectors can be
controlled with one
computer by connecting
SERIAL PORT IN. of
another projector to this
terminal.
is not
R/C JACK
When using Wired / Wireless
Remote Control Unit as Wired
Remote Control, Connect
Wired Remote Control Unit to
this jack with Remote Control
Cable (supplied).
USB PORT (Series B)
This port is used to service the
projector.
Connect USB port of computer to
this port.
RESET BUTTON
This projector uses a micro processor to
control unit. Occasionally, micro processor
may malfunction and need to be reset. This
can be done by pressing the RESET button
with a pen, which will shut down and restart
unit. Do not use RESET function excessively.
AUDIO OUTPUT JACKS
Connect an external audio
amplifier to these jacks.