Install The Hood; Grounding Instructions - Best K30 Mode D'emploi

INSTALL THE HOOD

1. Hang the hood from the brackets through
the rectangular cut-outs on the back of
the hood.
Cut-outs are larger than the brackets to
allow for horizontal adjustment.
The bottom of the hood should be 24" to
30" above the cooking surface.
2. Height adjustment screws provide vertical
adjustment.
3. Depth adjustment screws provide hori-
zontal adjustment.
4. Secure the hood with mounting screws
(4.8x38mm).
Use drywall anchors, provided, if wall studs
or framing are not available.
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by a
qualified electrician in accordance with all
applicable national and local electrical
codes.

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event
of an electrical short circuit, grounding
reduces the risk of electric shock by providing
an escape wire for the electric current. This
appliance is equipped with a cord having a
grounding wire with a grounding plug. The
plug must be plugged into an outlet that is
properly installed and grounded.
WARNING - Improper grounding can result in
a risk of electric shock.
Consult a qualified electrician if the grounding instructions are not completely
understood, or if doubt exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified
electrician install an outlet near the appliance.
Set the electrical power supply within the space covered by the decorative flues.
Position the power socket at a maximum distance of 33-7/16" (85 cm) from where
the lead exits from the hood (see illustration alongside). Make sure this does not
interfere with the decorative flue (where the flue touches the wall).
Fit the plug into the power socket.
MOUNTING
SCREWS
(4.8x38mm)
HEIGHT
ADJUSTMENT
SCREWS
MOUNTING SCREWS
(4.8x38mm)
- 6 -
RECTANGULAR
CUTOUTS
MOUNTING
BRACKETS
WALL
FRAMING
DEPTH ADJUSTMENT
SCREWS
33-7/16"
(85cm)
max