Telcoma Automations ZEN 100 Mode D'emploi page 59

GB
TAB. 3
Function
Input mode
Step/step
Radio Channel ch1
Output mode
Flashing light
Re-close
end of closing
Deceleration
Edge Input
*INVERSION STROKE AT END OF CLOSING
3) after three seconds led LD1 (and indicator lamp) turns on.
The selected level is stored in the memory.
N.
OFF ON Desciption
Dip
•
1
Open - Stop - Close
•
2
•
1
Open - Close
•
2
•
1
Open
•
2
Condominium function
•
1
Open - Close
•
2
Cut out of opening control
•
3 Flashing light
•
4 (lamp.)
•
3
Pulse 230V
•
4
•
3
Courtesy light
•
4
•
3
Indicator light
•
4
•
Inhibited
5
•
Enabled
•
Inhibited
6
•
Enabled
•
Inhibited
7
•
Enabled
•
Inhibited
8
•
Enabled*
•
Inhibited
9
•
Enabled
•
NC Input
10
•
balanced Input
when pressed again. During closure, when pushbutton S/S is pressed the door
seconds and then closes. During closure, when pushbutton S/S is pressed the
During opening, there is no action when pushbutton S/S is pressed, and when the door
is open the S/S button restarts the pause time. During closure, when pushbutton S/S is
During opening, there is no effect when pushbutton S/S is pressed. During the pause,
when pushbutton S/S is pressed the door closes. During closure, when pushbutton S/S is
enabled by connection of a standard lamp (230V) to terminals 6 and 7.
One second pulse (230V) every opening movement (the beginning of movement)
The output (terminals 6 and 7) becomes a "courtesy light" 230V maximum 100W.
Lit during manoeuvres plus a delay of approx. 2 minutes.
the indicator turns off.
After complete opening, the control unit only re-closes with a manual command.
After complete opening, the control unit re-closes after a set pause time.
Function inhibited
power pulse at end of closing Useful for completing manoeuvres on up-and-over doors.
Function inhibited
Impulse contrary to end of closing with the aim of relieving mechanical stress
and facilitating door release if necessary.
When deceleration is enabled the motor on approach to each end of manoeuvre
cuts to half the previous speed.
Any safety edges connected must have an NC contact (see table 2)
Any safety edges connected must have an NO contact with 8K2 resistance in
parallel (see table 2)
Notes
59