Telcoma Automations ZEN 100 Mode D'emploi page 52

GB
Fig. 11 Fig. 12
GEARMOTOR INSTALLATION: insert the gearmotor in the rear end section of the guide until the drive shaft H
is completely inserted. Facilitate this operation by turning the gearmotor. Then secure the gearmotor by means
13), thus positioning the courtesy light towards the exterior.
Fig. 13
Z124 ELECTRONIC CONTROL UNIT
The automations ZEN 100 and ZEN 60 are equipped on board with a control board model Z124, from which all
electrical connections are made (motor, encoder, power supply, etc.) with a connector for a radio receiver mod.
OC (optional) and a screw terminal for the courtesy light.
52