Telcoma Automations ZEN 100 Mode D'emploi page 56

GB
DOOR POSITIONING MANOEUVRE
This procedure enables manoeuvring as required of the door connected to the gearmotor, to prepare the system for
During this operation, the pushbuttons work in "hold-to-run" mode and safety devices are ignored.
Procedure:
3) After three seconds led LD1 turns on.
5) Activate the manual movement function by pressing PROG again
7) Press S/S to open the automation.
6
Exit
MANUAL DOOR RELEASE
To open the door, also without power, proceed as follows:
- for safety reasons, disconnect the 230V power supply
- move to below the guide in the vicinity of the release tie-rod
Fig. 16
56