ESAB EPP-400 Manuel D'instructions page 109

sectIon 4
4.2 control panel (con't.)
j
k
l
G - Panel Remote Switch
Controls the location of current control.
• Place in the PANEL position for control using the current po-
tentiometer.
• Place in REMOTE position for control from an external signal
(CNC).
H and L - Remote Connection
Amphenol 19 pin plug (J1) and 10 pin plug (J6) for connecting power source
to CNC.
I - Pilot Arc HIGH / LOW Switch
Used to select amount of pilot arc current desired. As a general rule, for 100
amperes and below, a setting of LOW is used. This can vary depending on
gas, material and torch used. High/Low settings are specified in cutting data
included in the torch manual. When the EPP-400 is set to marking mode, this
switch must be in the low position.
h
I
109
f
operatIon
g
a
c
B
D
e