Before The First Use - Princess 352712 Mode D'emploi

Instruction manual

BEFORE THE FIRST USE

Before starting operations in this section:
• Find a place where there is power supply nearby.
• Install the exhaust hose and adjust the window position well.
• Insert the power cord into a grounded AC220~240V/50Hz socket.
• Press the power button to turn on the air-conditioner.
• Check whether the exhaust hose has been mounted properly.
• Set the temperature range: 16°C-31°C.
• When using functions on cooling and dehumidifying, allow at least
3 minutes between powering off and powering on.
USING THE ON DEVICE BUTTONS
Cooling operation
• Press the "Mode" button till the "Cool" icon appears.
• Press the + <Temperature up> or - <Temperature down> button
to select a desired room temperature.
• Allow around 5 minutes for the cooling to start.
• Press the "Fan speed" button to adjust airflow speed.
Dehumidifying operation
• Press the "Mode" button until the "Dehumidify" icon appears.
• The temperature will automatically be selected.
• The fan speed will automatically be selected.
Fan operation
• Press the "Mode" button till the "Fan" icon appears.
• Press the "Fan speed" button to adjust airflow speed.
Timer operation
Timer ON setting
8
• When the air-conditioner is OFF, press the "Timer" button and
select a desired ON time and adjust by using the <Temperature
up> and <Temperature down> buttons.
• The ON time can be adjusted to anytime in 0-24 hours.
Timer OFF setting
• When the air-conditioner is ON, press the "Timer" button and
select a desired OFF time and adjust by using the <Temperature
up> and <Temperature down> buttons.
• The OFF time can be adjusted to anytime in 0-24 hours.
Swing operation (oscillation mode)
• Press this button to start the oscillation mode, the louver will
swing continuously up and down. Press button again to stop the
operation.
Sleep operation
• In cooling mode, press the "Sleep" button to set the temperature.
The set temperature is increased by 1 degree within one hour to a
maximum of 2 degrees after 2 hours.
• Press "Sleep" button to cancel the operation.
Drainage
• After a lengthy operation and before storage, you will need to
drain the water that has been collected. Please prepare a suitable
location or tray to collect the water and remove the rubber stop
from the drainage hole at the bottom of the unit. The water will
then begin to drain. After this has stopped, you can insert the
drain stop.