Setting The Lens; Record Videos - Reely X6 Notice D'emploi

b) Setting the Lens
Depending on the desired reception angle, it is possible to
change the angle at which the camera lens (1) is viewed´. For
this, there is the possibility to manually set the camera head
manually before the flight.
c) Record Videos
First switch on the transmitter and then connect the flight batte-
ry to the model. The LED of the camera electronics (1) initially
lights up red, then flashes thrice alternatingly red/green and
then remains lit green.
The camera unit is now ready for operation.
If the memory card is not or incorrectly inserted, the
LED lights up red for a while and then goes out.
To record a video, push the operating button for the video ca-
mera (see figure 1, item 11) once briefly to the top/front. The
remote control emits a long signal sound as confirmation. The
blue LED in the middle of the housing top starts flashing slowly
and thus indicates the recording mode of the camera.
The LED of the camera electronics flash red while a video is recorded. To terminate video recording, push the opera-
ting button for the video camera once briefly up/forward again. The LED at the housing top now is lit blue permanently
again and the camera LED is lit green.
Caution, important!
The video recording must be terminated by operating button in nay case, since the video data recorded
cannot be read from the memory card otherwise.
58
Figure 22
Figure 23