Inserting The Flight Battery - Reely X6 Notice D'emploi

c) Inserting the Flight Battery
The light battery is installed in the hexacopter from below. For
this, the housing lid with the camera holder must be removed.
Put the hexacopter onto a soft surface with the underside up.
Then turn the housing lid with the camera holder (1) gently a
little counter-clockwise to the left so that the three latching tabs
(2) at the edge of the circular lid unlatch.
Fold the housing lid to the side and guide the connection cable
of the flight battery (3) through the intended opening (4). Now
insert the flight battery (5) into the battery chute and observe
that you do not clamp or damage the connection cables of the
camera.
Then apply the lid again and observe that the camera head is
between the two arms with the red propellers.
When the lid is cleanly aligned and no cable is caught, turn the
lid carefully clockwise again.
Figure 9
47