Modifying The Steering Directions (Reverse Function) - Reely X6 Notice D'emploi

i) Modifying the Steering Directions (Reverse Function)
Your remote control is aligned with your hexacopter precisely ex works and does not need to be changed.
However, if during trimming, you notice that your hexacopter responds contrary to the pattern illustrated in figures
12 - 14 for the control functions, then you can switch the reaction direction for the nod, rolling and yaw control functions
of the model at the transmitter. For this purpose, there are four reverse switches on the rear of the folding operating
unit below a cover flap (also see figure 2, item 16). The switches are assigned the following functions:
Switch
1
2
3
4
To switch over a steering function, first disconnect the flight bat-
tery in the hexacopter, then switch off the transmitter and push
the corresponding reverse switch in the other switch position.
After re-commissioning of the transmitter, the square switch
icon of the respective control channel must appear on the other
side of the separating dash in the display.
For better understanding, the bottom illustration in figure 20
shows the display when the reaction direction for the nod func-
tion (2) is switched to „REVERSE".
Now you can start up the transmitter again, connect the flight
battery and check the correct function direction at the hexa-
copter.
56
Function
Roll function
Nod Function
Yaw Function
No function
Factory Setting
OFF
OFF
OFF
OFF
Display
1
2
4
-
Figure 20