Basic Information Relevant To The Control Of Multicopters - Reely X6 Notice D'emploi

e) Basic Information Relevant to the Control of Multicopters
Before you fly your model, you should first familiarise yourself with the control possibilities open to you and thereby
be able to fly safely.
The symmetrical setup of the model makes it very difficult to assign the alignment (front/rear). Therefore, the propel-
lers of the two arms pointing forward are made of red plastic.
The hexacopter is controlled via the two control sticks at the remote control transmitter. The following functions are
available:
Pitch Function
With the pitch function you can control the flying height of the hexacopter (see figure 11). The left control stick (also
see figure 1, item 10) is used for control. To that effect, the control stick can be moved forward and backward. Unlike
with other control functions, the lever does not keep springing back to the centre position.
Depending on the control stick position, the speeds of the six propellers change. If the control stick has been pulled
all the way to the body, the motors are switched off.
If you push the control stick from the bottom position forward, the propellers start up and increase the speed according
to the position of the lever. Once the control stick is in the centre position, the propeller speeds should be high enough
for the hexacopter to hover. If the control stick is pushed forward further, the hexacopter will rise. If the control stick is
pulled back, the hexacopter drops.
Figure 11
49