Quick Start - Samson G-TRACK PRO Manuel Du Propriétaire

Quick Start

Follow this simple quick start for a typical set-up to start recording.
Using the G-Track Pro with a computer
1. Position the G-Track Pro on your desktop by using the included microphone
base.
2. Set the G-Track Pro's pattern switch. If you are recording a single person,
set the switch to the Cardioid position and be sure to face the front side,
with the Samson logo. If recording two people, set the microphone to the
Figure-8 position and if recording multiple subjects, set the switch to the
Omni position.
3. Connect headphones to the Headphone output located on the rear of the
microphone.
4. Plug the USB cable into the G-Track Pro and plug the other end of the cable into an
available USB port on your computer.
5. Set the G-Track Pro as the input and output audio device by following the steps in
the section "Connecting to a Computer".
6. Launch your recording software.
7. Turn down the output VOLUME control on the G-Track Pro and if not already set,
select the G-Track Pro as the input and outputs in the software.
8. Create two mono audio tracks. Set one track to G-Track Pro Left Input for the
microphone input and the other track to G-Track Pro Right Input for the instrument
input. Note: Input names may vary depending on software.
9. Arm the tracks for recording.
10. Set the input levels of the microphone by following the steps in the section "Setting
Levels".
11. Set the direct monitor setting by following the steps in the section "Direct Monitor".
12. While singing/speaking or playing your instrument into the G-Track Pro, raise the
VOLUME control until the audio output is at a comfortable listening level.
13. Press the record button and start creating.
Owner's Manual 5