Manual Mode - CAME BPT TH/500 Manuel D'installation Et D'utilisation

①
①
When the period set is over, the device will go back to operating in automatic mode. To stop timed manual
mode just change mode by pressing the

Manual mode

To activate this mode press button
until the
Use the
zone temperature B; the value entered
A
will remain valid until the operating mode
or value set is changed.
Note. If no button is pressed for 5 seconds
the device goes back to showing the tem-
perature detected.
Timed manual mode
If you want to keep the temperature manual
B
for a limited period, briefly press on area ①
of figure B.
The appearance of the
that timed manual mode has been activated;
use the
and minutes (in 15 minute portions) during
which the mode will be active.
If you want to set an activation time for the
timed manual mode that is greater than 24
C
hours, press on area ① of figure C and
use the
days during which the mode will be active.
If no button is pressed for 5 seconds
the adjusting arrows disappear and the
countdown begins D.
D
button.
icon appears B.
arrows to set the desired
icon C indicates
arrows to set the value in hours
arrows to set the value in
A