Subwoofer - Q Acoustics 3060S Manuel Du Propriétaire

Multi-Channel AV System
For Stereo System connection, see next section.
Connections
Standard Connection is via the Line level RCA phono Inputs. For a typical AV system set-up you
will need a single RCA phono interconnect. As this cable is likely to be quite long, make sure you
get a good quality fully screened cable. Your Q Acoustics dealer will be happy to supply you with
a suitable interconnect.
AV AMPLIFIER
RIGHT LEFT
+
REAR LS
-
Connect the SUBWOOFER OUTPUT on the AV amplifier to the L/Mono Line input on the
subwoofer, pushing the plugs firmly home to ensure a good contact.
Setting Up
Check that all system connections are properly and securely made. Ensure that the subwoofer
is switched off.
Set the controls to the following default settings:
Level
Crossover
Phase invert
Auto on
Plug the supplied power cord into the subwoofer and then into the AC supply socket. Switch on
the power at the supply socket and then switch the power switch on the subwoofer to 'ON'. The
POWER light on the subwoofer amplifier panel will glow and the subwoofer is operational.
Check the settings on your AV amplifier to make sure that the subwoofer is set to 'ON 'or YES. The
subwoofer level on the AV amplifier should be set at its default position or 0dB. You should already
have set the speaker sizes and positions for all the other speakers in your system. If you have the
option to set the crossover frequency on the other channels make sure this is set appropriately to
your speakers: the 3010i, 3020i and 3090Ci should have the foam bung inside the port tube and
set to "small" and a crossover of 80Hz on the AV amplifier. Whereas, the 3050i should be set to
"large" without a foam bung and does not require a crossover setting. Finally, set the distance (or
delay) setting that is correct for the subwoofer position you have chosen.
RIGHT LEFT
+ +
CENTRE LS FRONT LS
- -
Approximately half
Fully clockwise (AV setting)
0°
AUTO or ON
9

SUBWOOFER

LINE IN
LEFT /
MONO
SUB OUT
RIGHT