Intended Use; Scope Of Delivery - VOLTCRAFT FG 8210 Notice D'emploi

3. INTENDED USE

The function generator FG 8210 generates measuring signals from 100 mHz up to 10 MHz with different signal
forms and adjustable amplitude and symmetry. The display shows the functions.
The following functions are available:
- Signal forms: Sine, rectangle, triangle, DC
- TTL-synchronous output
- Linear wobble function
- DC offset setting
- Voltage-controlled frequency setting (VCF)
- Frequency counter up to 100 MHz
The measuring connection is established via the BNC measuring sockets. The outer conductors of the BNC con-
tacts are all connected to the ground potential of the protective ground.
The maximum input values as compared to earth potential must not be exceeded.
To comply with the specifications, the device must be switched on at least 30 minutes before the measurement
starts.
For use in dry indoor areas only.
The product is set up according to protection class 1. The voltage source must be a proper mains socket of the
public mains with a ground contact. The mains socket must be close to the device and easily accessible or must
have an emergency stop device.
Operation under unfavourable ambient conditions is not permitted. Unfavourable ambient conditions are:
- Dampness or too high humidity
- Dust and flammable gases, vapours or solvents.
- Thunderstorms or similar conditions such as strong electrostatic fields, etc.
Any use other than that described above damages the product. Moreover, this is linked to dangers such as short
circuit, fire, electric shock, etc. No part of the product must be modified or converted! Always observe the safety
information!

4. SCOPE OF DELIVERY

• Function Generator FG 8210
• BNC-measuring line (BNC → alligator clamps)
• Mains cable
• Spare fuse
24