P2P Function - Urmet NVR Boost 2.0 Série Guide Rapide

NOTE: It is needed to set the Data Port (i.e. 9000) for iUVS Software Mobile correct working. If the user sets the
Mobile Port, iUVS Software Mobile cannot work for any reason.
To delete a device from list, swipe the device name you want to delete, then tap the delete button next to the device
name.
7.2

P2P FUNCTION

Plug the mouse into the USB port.
1.
Connect the "VGA" and/or "HDMI" video output to the respective VGA/HDMI monitor to view the previously
2.
connected cameras.
Plug the network cable into the LAN port.
3.
Power the NVR using the transformer contained in the box.
4.
Connect the respective required cameras to the input IP channel and set the IP Cameras from IPC Setup Menu.
5.
The NVR Urmet network is configured in DHCP mode (automatic IP address allocation) by default. This means
6.
that the network to which the NVR is connected must support the DHCP service. In this manner, simply view the
parameters that the device acquires automatically from the network in the "Network" menu of the NVR. Wait for
approximately ten seconds for the parameters to be allocated and appear automatically in the menu: IP
address, subnet mask, gateway and DNS (see below).
7. In the NVR menu, select "System" -> "Users" to enable and customise the password for the "admin" and/or
"user" level.
8. Download and install the iUVS app from the Store.
Launch the "iUVS" app and select "Devices" and then "Add".
9.
DS1093-133B 49