Feedback From A Receiver, Menu Messages - Selve commeo Multi Send Notice

GB Programming

8.5. Feedback from a receiver, menu Messages

In the menu Messages you will get messages concerning the receiver. When a new
message was received you will see that in the operating mode with the letter symbol
in the display. In this message you will be informed on the report number, reason,
receiver name as well as the time. The messages can be deleted in the menu
Messages.
The messages are dependent on the receiver type and its connection as well as on the
set sensors. The most important messages which will be shown are:
Message
Overload
Obstacle
Radio
Sensor loss
Alarm
Wind alarm
Command not exe-
cuted
The menu Messages is selected.
With the buttons
the list.
With the button
menu without deleting the message store.
With the button
You have pushed the button
sages should be deleted.
With the button
menu without deleting the message store.
With the button
empty list of the messages will be shown.
With the button
Cause
One drive was blocked during the movement.
One drive has been moved onto an obstacle.
One receiver did not confirm the moving command.
One in the receiver programmed sensor does no longer
send signals to the receiver.
A sensor has given the alert or there is an emergency signal
on the extensions.
A wind sensor has given a wind alarm.
A command could not have been executed from the receiver.
and you can move up and down within
you will get back into the menu Main
you will delete the message store.
. You will be asked if all mes-
you will get back into the menu Main
you will delete the message store. The
you will get back into the Main menu.
52