Set Target Position For Switching Times, Menu Target Program - Selve commeo Multi Send Notice

Programming

8.4.2. Set target position for switching times, menu Target program

In the menu Target program it is possible to fix a target position for the switching off
and switching on times of groups and centrals. In the factory setting the target position
for a switching on time is set to upper end limit positon and for switching off time is set
to lower end limit position. The following positions can be approached:
Upper end limit position, drive moves to its upper end limit position.
Lower end limit position, drive moves to its lower end limit position.
Intermediate positon 1, can be set via the hand-held transmitter on the receiver
(see 7.6.).
Intermediate position 2, can be set via the hand-held transmitter on the receiver
(see 7.7.).
No target position but an approval of the sun automatic at the same time pro-
grammed sun sensor. The receiver will move the system into the daily neutral
position.
No target position but a blocking of the sun automatic at the same time pro-
grammed sun sensor. The receiver will move the system into the nightly neutral
position.
Note: The position of the neutral position is dependent on the setting of the receiver
use.
The menu Target program is selected.
With the buttons
position that needs to be changed. By pushing the button
the selected position will be changed. By pushing the button
several times you will get to the target position.
With the button
istration without saving.
With the button
into the menu Administration.
, , and you will choose the target
you will get back into the menu Admin-
you can save the settings and get back
49
GB
GB