Residual Risk; Guide To Parts Breakdown - Kiva MINIUM Manuel D'utilisation

INFORMATION ON SAFETY DECALS CONT'D...
DANGER
ROTATING CUTTING BLADES
KEEP HANDS AND FEET OUT OF INLET AND DISCHARGE OPENINGS WHILE MACHINE IS
OPERATING TO AVOID SERIOUS PERSONAL INJURY. STOP ENGINE, REMOVE SPARK PLUG WIRE
AND ALLOW MACHINE TO COME TO A COMPLETE STOP BEFORE CLEARING OBSTRUCTIONS OR
MAKING ADJUSTMENTS.
DANGER
SHIELD HAS BEEN REMOVED.
DO NOT OPERATE WITHOUT SHIELD IN PLACE. SERIOUS INJURY OR EDATH MAY OCCUR.
CAUTION
READ ALL THE SECTIONS IN THISMANUAL PRIOR TO ATTEMPTING TO SERVICE, MAINTAIN OR
OPERATE THIS EQUIPMENT.
DO NOT
OPERATES THIS EQUIPMENT UNTIL YOU HAVE READ AND UNDERSTOOD ALL THE ENCLOSED
OPERATOR'S MANUAL.
CAUTION
DO NOT ATTEMPT TO PERFORM ANY REPAIRS, SERVICE, OR DIAGNOSTICS, OR TO TRANSPORT
OR MOVE THE UNIT UNTIL ALL MOVING PARTS HAVE COME TO A COMPLETE STOP. FAILURE TO
DO SO MAY RESULT IN SERIOUS INJURY OR DEATH.
SHREDDING Ø Max. 20MM
CHIPPING Ø Max. 40MM

Residual risk

Even when the product is used as prescribed, it is still impossible to completely eliminate certain residual risk factors. The
following hazards may arise in use and the operator should pay special attention to avoid the following:
Exposure to noise can cause hearing injury.Wear ear protection and limit exposure.
Inhalation of dust and particles. Wear dust mask / filter when necessary.
Contact with the cutting mechanism. Keep unprotected body parts away from the cutting mechanism at all times.
Regular maintenance and parts replacement are important steps to extending the life of your
equipment and enjoying its optimum performance. When performing or conducting any maintenance
or repairs, always check that your working surroundings are safe and well-ventilated and that the
technician is familiar and comfortable with all aspects of the machine and required procedures.
This guide aims to serve as a representational guide to the KLB2400E. Any other uses or application
beyond the scope of this document are strictly prohibited. While every attempt has been made to
maintain its accuracy, KIVA SAS reserves the right to update and modify the equipment without prior
notification. Prior to undertaking to perform any maintenance or repair procedures, please contact our
Technical Support Hotline for clarification and to acquire appropriate parts.
To order spare parts, please provide the following information:
1. Machine Make
2. Model Number
3. Machine Serial Number
4. Quantity Required of Each Part
5. Part Numbers
6. Part Descriptions.

GUIDE TO PARTS BREAKDOWN

6