Assembly; Unpacking Instructions; How To Set Up Your Chipper/Shredders - Kiva MINIUM Manuel D'utilisation

15

ASSEMBLY

Carefully read these instructions and this manual in its entirety, before you attempt to operate your
new shredders.
Your new shredder/chipper has been pre-assembled at the factory, with the exception of those parts
left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc. necessary to
complete the assembly have been attached on the machine. To assure safe and proper operation of
your shredder/chipper, all parts and hardware you assemble must be tightened securely. Use the
correct tools needed to assure proper tightening.
I UNPACKING INSTRUCTIONS
INTRODUCTION
Please carefully follow these assembly steps to properly prepare your machine for use. We
recommend that you read this Section in it's entirely before beginning assembly.
INSPECTION AFTER DELIVERY
When unpacking the machine, inspect for shipping damage or missing parts, if you find any
damage, or if parts are missing, notify the WEIBANG Dealer who sold you the machine.
TOOLS/MATERIALS NEEDED:
Active Wrench
UNPACKING STEPS
Cut plastic banding. To open the box, remove top plywood panel firstly,
Remove the filling hopper and the feed intake opening tube.
Remove all around wall panel.
Remove machine from the wood pallet.
Check the box thoroughly and remove additional loose parts included with the shredder/chipper.
Remove all packing materials.
II HOW TO SET UP YOUR CHIPPER/SHREDDERS
PREPARATION
The following parts must be in the packaging before the shredder can be assembled:
Shredder
Filling hopper and feed intake tube.
Operating indtructions
Si toutefois l'une de ces pièces manquait, merci de contacter votre revendeur.
WARNING:To prevent personal injury or property damage, do not
attempt to start the motor until all assembly steps are complete
and you have read and understand the safety controls and
operating instructions in this manual.
NOTE: All references to left, right, front and rear of the machine are
determined by standing behind the handlebars and facing the direction
of forward travel.
CAUTION:Wear protective gloves during operation of setting up
your shredders/chippers.